GE Energy
20
994-0089–1.00–2, General
2.2 Required Tools
Before beginning the installation procedures, have the following tools and equipment
available:
• Ethernet cable(s)
• Flathead screwdriver with 0.6 mm by 3.5 mm blade (for terminal block wiring)
• Flathead screwdriver with 0.3 mm by 2.5 mm blade (for removing and installing the
adapter cards and changing switch positions)
• #1 Phillip screwdriver (for power terminal block wiring and adapter card removal)
• #2 Phillip screwdriver (for rack mounting the unit)
• Needle-nose pliers
• Wire cutters
• Wire strippers
• Wire-crimping tool (Panduit
®
CT-1525 or equivalent)
• 6 fork connectors, Panduit part number PV14-6F for 14-16 AWG wire or PV18-6F for
18-22 AWG wire (or equivalent) for terminal block connections
• 1 ring connector, Panduit part number PV10-14R for 12 AWG wire (or equivalent) for
protective earth terminal
• Approved network settings for the device (default IP-Address: 192.168.168.81; default
Subnet Mask: 255.255.255.0)
• Windows-based PC with HyperTerminal
®
(or any Windows-based terminal emulation
software) installed
