A SERVICE OF

logo

QSā€“28 UR SWITCH MODULE ā€“ QUICKSTART GUIDE
QUICKSTART GUIDE
Z Locate and click on the Ethernet card (it will have TCPIP Protocol
as part of its name).
The Ethernet card is typically referred to as an Ethernet adaptor.
Z Select ā€œUse the following IP addressā€.
Z Enter a unique IP address (from 3.94.247.001 to 3.94.247.254 if
using our test network address range).
Z Enter the subnet mask which, if using our test network, will be
255.255.252.0.).
Z Plug into the switch and ensure that the link LED comes on.
Z Select OK, then OK again to exit the LOCAL AREA NETWORK
PROPERTIES menu.
Z