A SERVICE OF

logo

5
Using the Battery Charger:
1. Remove the Battery Compartment Cover on the back of the Wireless USB Receiver.
2. Install two Ni-MH rechargeable AAA batteries into the Wireless USB Receiver following the battery orientation guide
in the battery bay.
3. Replace the cover back onto the Wireless USB Receiver.
4. Turn on your computer and connect the Wireless USB Receiver into an available USB port on your computer, the
Wireless USB Receiver will begin charging the installed Ni-MH rechargeable batteries.
5. There are two LED indicators on the Wireless USB Receiver:
LED Status Description
Connection LED Solid Red Inactive/Mouse Not Detected
Flashing
Red
Mouse Detected and It Is Active
Blinking
Red
Scanning Mouse Connection
Battery
Charging LED
Solid Red Charging Battery
Off No Battery Installed/Battery Is Fully
Charged