Grizzly G0698 Manual

A SERVICE OF

next previous

"')"

BdYZa<%+.-B[\#h^cXZ&%$%.

Installing Headstock

Faceplate

3. Jh^c\i]Z^cXajYZY)bb]ZmlgZcX]!i^\]iZc

i]ZildhZihXgZlhVadc\i]Z^ch^YZY^VbZiZg

d[ i]Z [VXZeaViZ id hZXjgZ ^i id i]Z he^cYaZ

hZZFigure 27#

To prevent the faceplate and workpiece

separating from the spindle during opera-

tion, the headstock faceplate MUST be firmly

threaded onto the spindle and secured in

place by fully tightening the two faceplate

set screws. If these instructions are not

properly performed, serious personal injury

could occur.

Note: To remove the headstock faceplate, discon-

nect the lathe from the power source and perform

the steps above in reverse.

=ZVYhidX`;VXZeaViZ

Figure 27.=ZVYhidX`[VXZeaViZhZihXgZl#

To install the headstock faceplate:

1. 9>H8DCC:8IA6I=:;GDBEDL:G

2. I]gZVYi]Z[VXZeaViZdcidi]Zhe^cYaZjci^a^i

^hhcj\#>[cZXZhhVgn!^chZgii]Z^cYZm^c\e^c

^ciddcZd[i]Z^cYZm^c\]daZhVcYgdiViZi]Z

he^cYaZjci^ai]Ze^cZc\V\ZhidegZkZcii]Z

he^cYaZ [gdb ijgc^c\ l]^aZ ndj i^\]iZc i]Z

[VXZeaViZFigure 26#

Figure 26.AdX`^c\he^cYaZl^i]^cYZm^c\e^c#

;VXZeaViZHZiHXgZl&d['