33
English
3.4 Adjusting Channel Settings
1 Press MENU to enter the OSD Main Menu
screen.
2 Press / on the remote control or
CHS
/ CHT on the control panel to select
Channel menu.
3 Press / OK on the remote control or
INPUT on the control panel to enter the
Channel menu.
4 Press / on the remote control or CHS / CHT on the control panel to select an
item.
5 Press / OK on the remote control or INPUT on the control panel to enter the item.
6 Press / on the remote control or VOL+/ VOL- on the control panel to change
the scales or press OK on the remote control or INPUT on the control panel to mark
an item.
7 Press RETURN to return to the Channel menu.
8 Press MENU to exit the Channel menu.
9 The Channel menu can be used to perform a channel search and edit channel list
(see “Performing an Automatic Channel Search” on page 28 and “Editing Channel
Table or Favorite Channel” on page 29).
•The Antenna can be set to Air or Cable.
•The Scan Mode can be set to
Auto, Analog, or Digital.
•The Auto Scan can be set to
Auto, Standard, HRC, or IRC (under Cable mode
only).
Note:
The Channel settings are available when the signal is set to TV source.
Picture
Audio
Channel
V-CHIP
Setup
Antenna
Scan Mode
Auto Scan
Channel List
ExitReturnEnter
Menu
Move
Return
OK
