40
care and maintenance
hp fax 1010 series
The broadcasting and delayed fax can hold 5 jobs in total. Cancel a
scheduled job and try again.
The print cartridge is low or has run out of ink. To install a new print
cartridge, see replace the print cartridge on page 34. Although this
message is displayed, you can make a copy or print a report.
Incoming faxes will be stored in memory. You must manually print
them, see reprinting faxes on page 29.
Print cartridge is not installed or improperly installed.
The print cartridge should be installed to copy, print a report or
receive a fax.
You attempted to cancel a scheduled job but no jobs are scheduled.
You attempted to delete a junk fax number when there is no junk fax
number.
The machine can hold only 20 junk fax numbers.
You must load a document before preceding.
Memory has become full while receiving a fax. It will not answer the
telephone until memory has been cleared. Print any faxes stored in
memory and, if necessary, clear scheduled jobs See reprinting faxes
on page 29 and see clearing memory on page 29.
Memory has become full while scanning a document. Press
Start/Enter
to send or copy the scanned pages only. To cancel the job press
Cancel
and try again when memory becomes available, or split the
new document into smaller parts. See clearing memory on page 29.
The machine has data stored in memory. Replace the print cartridge
with new one in order to print the faxes.
Load paper and press
Start/Enter
. There might be a jam. Clear the jam
as described in paper jams during printing on page 35.
There is no print cartridge in the machine. Install a print cartridge.
The machine is low on ink and has received faxes into memory. You
must replace the print cartridge (see replace the print cartridge on
page 34) and reprint the faxes from memory (see reprinting faxes on
page 29).
The other machine has not answered after all redial attempts to send a
fax.
The machine could not detect the CID (Caller ID) number.
There is no number in the redial memory.
The number you are searching for does not exist in memory.
The number you are trying to enter already exists in the phone book or
junk fax list.
There is no number assigned to this One-Touch or two-digit Speed
number.
The remote user entered the wrong poll code.
You have already programmed a polling send. Cancel scheduled job
and try again.
Display Status/Solution
