9. Repeat if necessary for the other print cartridge.
10. Gently close the print cartridge door and plug the power cord into the back of the
product.
Cause: The print cartridge contacts needed to be cleaned.
If this did not solve the issue, try the next solution.
Check paper
Try the following solutions.
•
Step 1: Make sure only one type of paper is loaded
•
Step 2: Load the stack of paper correctly
Step 1: Make sure only one type of paper is loaded
Solution: Load only one type of paper at a time.
Cause: More than one type of paper was loaded in the paper tray.
If this did not solve the issue, try the next solution.
Step 2: Load the stack of paper correctly
Solution: Remove the stack of paper from the paper tray, reload the paper, and
then slide the paper-width guide inward until it stops at the edge of the paper.
For more information, see:
“
Load media” on page 23
Cause: The paper-width guide was not positioned correctly.
Check product
Try the following solutions.
•
Solution 1: Align the print cartridges
•
Solution 2: Automatically clean the print cartridges.
Chapter 6
40 Solve a problem
Solve a problem
