A SERVICE OF

logo

Install the
Printer Software
To ensure successful installation of the printer software:
1
Make sure your computer is fully set up and operational.
2
Check that the printer is properly set up and ready to
print using the instructions in this Setup Guide.
3
Make sure that the printer is directly connected to the
computer (remove any switch boxes or other devices
using the same port). Check that all cable connections
are firm.
4
Make sure the computer and printer are turned on.
5
Close any screen savers, virus protection programs
or other software programs that are running on the
computer.
I
NSTALLING
THE
P
RINTER
S
OFTWARE
FROM
CD-ROM
(
RECOMMENDED
)
If you have a CD-ROM drive, installation is easy. A few
seconds after inserting the printer software CD-ROM in
the drive, the installation program will start automatically.
It will recognize the attached printer and guide you through
the installation process. If the installation program does
not automatically run, see instructions on the following
pages. (Use the instructions for the operating system on
your computer.)
I
NSTALLING
THE
P
RINTER
S
OFTWARE
FROM
D
ISK
Follow the instructions on the following pages. (Use the
instructions for the operating system on your computer.)
STEP
6
If your computer does
not have a CD-ROM
drive and disks were
not included with your
printer see page 45 of
the user’s guide for
information on getting
printer software.
SetupGuide Page 10 Friday, July 25, 1997 1:13 PM