9. Close the print cartridge door.
NOTE: After closing the print cartridge door,
the Ready
light and Attention light will
flash. Allow up to three minutes for the
product to calibrate.
NOTE: If replacing another print cartridge,
you must close the print cartridge door before
pressing the Cartridge
button of the next
print cartridge.
You do not need to wait for the product to
calibrate when replacing the second print
cartridge. Instead, press the Cartridge
button for the next color to rotate the carousel
into position. After you have replaced the print
cartridges, the product calibrates.
NOTE: After every other black cartridge
change, a cleaning page prints automatically
to clean the fuser. This cleaning page process
takes two minutes to complete.
10. When printing, if you receive the status alert
message Wrong Cartridge in <Color> Slot,
remove the print cartridge from the specified
slot and compare the color label on the print
cartridge to the color label in the slot to
determine the correct print cartridge for the
slot.
ENWW Manage supplies and accessories 85
