A SERVICE OF

logo

Open as PDF
next previous
Removal and replacement procedures 55
5.
Remove the redundant fan, if applicable.
6. Remove the FBDIMM.
To replace the component, reverse the removal procedure.
Parallel and second serial connector bracket
To remove the component:
1. Power down the server (on page 27).
2. Do one of the following:
o Unlock and remove the bezel ("Front bezel" on page 29).
o Extend the server from the rack (on page 28).
3. Remove the access panel.
4. Push the release latches on the expansion board retainer and open the retainer.