Resolving paper-feed problems
For information on resolving jams, see Clearing jams.
Tray cannot be inserted
●
Reinsert the tray. Make sure it is aligned with the printer opening.
●
Check for paper jam. See
Clearing jams.
Another paper-feed problem is occurring
Media is not supported for the printer or tray
▲
Use only media that is supported for the printer and the tray being used. See
Understanding
specifications for supported media.
Media is not picked up from a tray
●
Make sure media is loaded in the tray. See Loading media. Fan the media before loading.
●
Make sure the paper guides are set to the correct markings in the tray for the media size you are
loading. Also make sure the guides are snug, but not tight, against the stack.
●
Make sure media in the tray is not curled. Uncurl paper by bending it in the opposite direction of
the curl.
●
Make sure the tray is inserted properly.
Media is not coming out correctly
●
Make sure the output tray extension is extended; otherwise, printed pages may fall off the printer.
●
Remove excess media from the output tray. There is a limit to the number of sheets the tray can
hold.
●
If the rear access panel or duplex unit is not installed properly during a print job, media may exit
through the rear of the printer. Reinstall the rear access panel or duplex unit, or close the cover
of the duplex unit.
ENWW Resolving paper-feed problems 47
