Security Overview
Getting Started with Access Security
CLI: Management Interface Wizard
To configure security settings using the CLI wizard, follow the steps below:
1. At the command prompt, type setup mgmt-interfaces.
The welcome banner appears and the first setup option is displayed
(Operator password). As you advance through the wizard, each setup
option displays the current value in brackets [ ] as shown in Figure 1-1.
Welcome to the Management Interface Setup Wizard
This wizard will help you with the initial setup of the various
management interfaces. The current values are shown in brack-
ets[]. Type in a new value, or press <Enter> to keep the cur-
rent value. Press CTRL-C at any time to quit the wizard without
saving any changes. Press ? for help.
Operator password [not configured]:
Confirm password:
Manager password [*******]:
Confirm password:
Restrict SNMP access to SNMPv3 only [no]:
SNMPv2 community name [notpublic]:
SNMPv2 Community access level [unrestricted]:
Telnet enabled [yes]:
SSH enabled [no]:
Web management enabled [yes]:
Restrict Web access to SSL [no]:
Timeout for ssh/telnet sessions [0]:
Operator password :
Manager password :*******
Restrict SNMP access to SNMPv3 only :no
SNMPv2 community name :notpublic
SNMPv2 Community access level :unrestricted
Telnet enabled :yes
SSH enabled :no
Web management enabled :yes
Restrict Web access to SSL :no
Timeout for ssh/telnet sessions :0
Do you want to save these changes? [yes]:
Current values are
shown in brackets
(Password entries
must be entered
twice and will
appear as asterisks.)
Type in a new
value to change a
setting, or press
<Enter> to keep
the current value.
To save these settings, press [Enter].
To cancel any changes, type [n] (for no), then press [
Enter].
Summary of current
settings (displayed
after last wizard
option has been set)
Figure 1-1. Example of Management Interface Wizard Configuration
1-12
