6
J
2-13
Remove hose
When using cleaning tools, cleaner
handle should be in the upright posi-
tion. Also, turn cleaner OFF before
disconnecting and connecting the
hose (J).
Remove hose end from cleaner base.
2-14
K
Attach wand and tools
The tools are attached to the hose or the
wand in the same manner.
Push tool firmly onto hose; twist tool slightly
to tighten or loosen connection.
Attach second wand or tool to the wand in
the same manner.
2-17
2-16
Extra reach hose
(available at additional cost)
The extra reach hose provides easier
cleaning of stairs and hard to reach
places. Follow the steps below for attach-
ing and detaching hose.
Turn cleaner OFF before disconnecting
and connecting hose.
Remove hose end from cleaner base.
Align end of extra reach hose with projec-
tions (L) with slots (M) on end of attached
hose.
Slide hose into slots and twist hose to
lock it into place. (To detach hose,
reverse procedure.)
Attach wands or tools to the other end of
hose.
L
M
2-15
Replacing hose
When you are finished cleaning with the
tools, use the end of the hose to push
the cover (K) down and push hose onto
opening.
Twist hose end slightly to tighten the
connector.
Hose must be connected to cleaner
base for floor cleaning.
How to clean tools
To clean the hose, wipe off dirt with a
cloth dampened in a mild detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air dry
before using.
