A SERVICE OF

logo

10
P/N 211017 2/05
3.
While maintaining alignment, bounce
assembly and bottom pole section (6)
together as shown until they no longer
move toward identification sticker.
5
4
While maintaining alignment, bounce pole top (4) and
middle section (5) together as shown until they no longer
move toward identification sticker. Upright assembly.
2.
WOOD SCRAP
(NOT SUPPLIED)
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM)
MINIMUM OVERLAP.
NOTE:
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM)
MINIMUM OVERLAP.
NOTE:
5
4
4
5
bottom pole
bottom pole
5"
1-1/2"
5
6
5
6
5
4
6
middle pole
IDENTIFICATION
STICKER
5"
1-1/2"
WOOD SCRAP
(NOT SUPPLIED)
IDENTIFICATION
STICKER
IMPORTANT!
Center alignment
slot of middle pole
section (5) in a lower
hole of top pole
section (4) as shown.
IMPORTANT!
Center alignment
slot of bottom pole
section (6) in a lower
hole of middle pole
section (5) as shown.
middle pole
IDENTIFICATION
STICKER
IDENTIFICATION
STICKER