Hunter Fan 42724-01 Manual

next previous

12345-01•12/06/07•HunterFanCompany

Steps 3-5 – 3-6

Low Proﬁle Screw

Low Proﬁle Washer

Steps 3-2 – 3-3

Downrod

Canopy

TrimRing

Set Screw

WARNING: Fan may fall if not assembled as directed in these

installation instructions.

3-1.Unbundlethewiresfromthefan.

For Standard or Angled mounting:

3-2. To assemble fan to hang down from a ﬂat or angled ceiling, insert

the downrod through the canopy and canopy trim ring. Feed the

wires from the fan through the downrod.

3-3. Loosen the square head set screw on the adapter to install the

pipe and ball assembly. Note: When the pipe and ball assembly

isfullyinstalled,2-3threadsonthepipewillstillbevisible;thisis

normal. Securely retighten the set screw with a wrench or pliers.

Skip to Step 3-7.

CAUTION: e adapter has a special coating on the threads. Do

notremovethiscoating;thecoatingpreventsthedownrodfrom

unscrewing.Onceassembled,donotremovethedownrod.

For Low Proﬁle mounting:

Note: For low proﬁle mounting, the downrod is replaced with the low

proﬁle washer.

3-4. Removethesetscrewfromtheadapter.

3-5. Place the low proﬁle washer (lip up) into the canopy. Be sure the

green ground wire is pointing up toward the ceiling.

3-6.Aligntheholesinthewasherwiththeholesintheadapter.

Assemblesecurelywiththreelowprolescrews.

3-7.Raisethefanandplacethehookontheceilingplatethroughthe

U-shapedholeintherim.

Step 3-7

U-shaped

Hole

3 • Assembling and Hanging the Fan