4-7
4. Printer Driver for WindowsNT
■ Copy Count:
Set the number of copies to be made. The allowable range is from 1 to 999. Setting can be made in the “Change ‘Copy Count’ Setting”
area. Click the arrow buttons (▲,▼) or enter directly from the keyboard. The factory default setting is “1”.
■ Print on Both side (Duplex Printing):
Allows you to set the desired duplex mode. Setting can be made in the “Change ‘Print on Both Sides “Duplex Printing”’ Setting area. The
factory default setting is “None”.
[None].........................................Does not print on both sides.
[Long Side] ................................Prints on both sides and binds along the longer edge.
[Short Side]................................Prints on both sides and binds along the shorter edge.
* 20 ppm copier: Available only when the optional Duplex Unit is installed.
* 15 ppm copier: Duplex printing is NOT available.
* Paper sizes, types and source of paper feed that are acceptable for duplex printing are as follows:
Paper sizes: Letter (8 1/2" x 11"), Legal (8 1/2" x 14"), Tabloid (11" x 17"), Statement (5 1/2" x 8 1/2"), A3, A4, A5, Folio (210 mm x 330
mm), JIS B4 and JIS B5
Paper types: Plain, Recycled and Color
Source of paper feed: Any tray EXCEPT the Bypass Tray
4-7 Graphic (KPDL2 Driver)
■ Resolution:
Specify the desired print resolution. The resolution must be specified in the number of dots per inch (dpi). Select between “600 x 600 dots
per inch” and “300 x 300 dots per inch”. The factory default setting is “600 dots per inch”.
