18
STACK menu settings
3. Press the ◄ button to return to the previous menu, or press the ► button to
save the setting. (
19
)
NOTE • <Only for IN5135 and IN5145> When the projectors are in the PbyP
mode, the SUB INPUT SOURCE is set to FOLLOW MAIN UNIT.
• If FIXED (COMPUTER IN 1) is selected, either the COMPUTER IN1 or IN2
port can be selected as an input source on the Main projector. When any
source button on the remote control or the INPUT button on the projector is
pressed, the MAIN INPUT SOURCE dialog will be displayed on screen. Select
COMPUTER IN 1 or COMPUTER IN 2 with the ▲/▼ buttons.
• If FIXED (COMPUTER IN 1) is selected, the COMPUTER IN1 port on the Sub
projector should be connected to the MONITOR OUT port on the Main projector
with a computer cable. The image from the selected port is output from the
MONITOR OUT port on the Main projector to the COMPUTER IN1 port on the
Sub projector. The MONITOR OUT setting on the Main projector is disabled
when FIXED (COMPUTER IN 1) is selected. (
Operating Guide
→ SETUP
menu)
• If FIXED (COMPUTER IN 1) is selected, video signals can be input to the
COMPUTER IN1 or IN2 port on the Main projector. Set the port for video signal
input in the COMPUTER IN menu and set the video format in the VIDEO
FORMAT menu. Refer to Inputting image from Main to Sub (
24
) and Inputting
image from Main to Sub - Video signal (either component or video).
(
28
)
3.5 Selecting input source for Sub
1.
Highlight SUB INPUT SOURCE in the STACK
menu with the ▲/▼ buttons, then press the ►
button to display the SUB INPUT SOURCE dialog.
2. Use the ▲/▼ buttons in the dialog to highlight FOLLOW MAIN UNIT or FIXED
(COMPUTER IN 1).
FOLLOW MAIN UNIT: Sets the input source on the Sub projector to the same
port as Main.
FIXED (COMPUTER IN 1): Sets the input source on the Sub projector to the
COMPUTER IN1 port which is connected to the MONITOR OUT port on the
Main projector.
