8
Setting up the Projector
Connecting the CableWizard™
3
to the Projector
CAUTION: Turn off the
computer, monitor and projector
whenever you connect or
disconnect cables.
The CableWizard
3
(referred to as “CableWizard” in this manual
for brevity) simplifies the connection process by providing a cen-
tral hub for all the connections between the projector and your
computer. The connectors on the CableWizard are labeled with
icons. The CableWizard also has an LED that lights solid green
when the projector is on and CableWizard is functioning prop-
erly. A slowly blinking LED indicates CableWizard is waiting to
initialize with the projector; a rapidly blinking LED indicates a
problem with CableWizard.
Connect the end of the CableWizard cable to the
connector on the projector’s connector panel (Figure 5).
NOTE: The projectors are
optimized for use with newer
CableWizards (2 and 3). If you
have a CableWizard 1from older
models of InFocus projectors, we
do not recommend using it as
image quality is reduced. The label
on the bottom reads CableWizard
or CableWizard II or
CableWizard
3
.
F
IGURE 5
Connecting the CableWizard to the projector
NOTE: In some older computers,
the monitor connector does not
have a hole for Pin 9. If you have
trouble connecting the
CableWizard cable to your
computer, contact InFocus
Technical Support.
