A SERVICE OF

logo

Page 8 of 24 2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM
Change to Latching Mode (default)
1) Press and hold set button until it beeps
LED will start blinking green
2) Press and hold set button until it beeps a second time
LED will start blinking red
3) Press and hold set button until it beeps a third time
LED will start blinking green
4) Slowly tap set button six times
LED will continue blinking green
5) Press and hold set button until it double-beeps
LED will stop blinking
6) Test mode change by tapping switch on and off
Load will respond appropriately
3-Way Toggle Mode (Latching Switches Only, Default)
Because Micro module comes programmed for latching switches, 3-way toggle mode is enabled by
default. Normally, a latching switch reads the switch’s up position as on and down position as off. For
example, if you turn Micro module on from the latching switch and off from another controller, the switch is
still in the up (on) position; turning Micro module back on from the switch would require you to tap the
switch down, then up again.
The 3-way toggle mode overrides this sense feature, so in that same scenarioturning Micro module on
at the switch and off from another controller, so switch is in up (on) positionyou could then turn Micro
module on at the switch by tapping it down.
If you are installing Micro module behind a single or dual momentary switch, 3-way toggle mode is
ignored. If desired, you can disable (or re-enable) 3-way toggle mode by following these instructions:
1) Press and hold set button until it beeps
LED will start blinking green
2) Press and hold set button until it beeps a second time
LED will start blinking red
3) Press and hold set button until it beeps a third time
LED will start blinking green
4) Press and hold set button until it beeps a fourth time
LED will start blinking red
5) Slowly tap set button 4 times
Micro module will beep
LED will continue blinking red
6) Press and hold set button until it double-beeps
LED will stop blinking
3-way toggle mode is now disabled (or re-enabled)