Chapter 5 Using the Command-Line Interface 93
bottom field and press Enter. Finally, press CTRL-X to save your
changes and return to the previous screen.
✔ To disable multicast communication, select disable multicast, and
press Enter.
✔ To enable HTTP redirection, select enable HTTP, and press Enter.
✔ To disable HTTP redirection, select disable HTTP, and press Enter.
✔ To enable NNTP redirection, select enable NNTP, and press Enter.
✔ To enable NNTP redirection, select enable NNTP, and press Enter.
✔ To add a router, select add router, and press Enter. Doing so causes a
field to appear. Supply the router IP and press Enter. Press CTRL-X to
save your changes and return to the previous screen.
✔ To delete all routers, select delete routers, and press Enter.
▼ Viewing current WCCP options
1 Select the config menu, and press Enter.
2 Select routing, and press Enter.
3 Select wccp, and press Enter.
4 Select view, and press Enter.
Configuring the Adaptive Redirection Module (ARM)
You can configure the ARM for transparent proxy caching, set bypass rules, and
configure load-shedding options.
Enabling and disabling transparent redirection
You can enable or disable transparent HTTP/NTTP.
▼ Enabling transparent redirection
1 Select the config menu, and press Enter.
2 Select arm, and press Enter.
3 Select nat, and press Enter.
4 Select enable, and press Enter.
▼ Disabling transparent redirection
1 Select the config menu, and press Enter.
2 Select arm, and press Enter.
3 Select nat, and press Enter.
4 Select disable, and press Enter.
