Invacare BAR750 Manual

A SERVICE OF

next previous

SECTION 4—PACKAGING, HANDLING AND SET-UP

Part No 1143215 23 BAR750

8. Pullthehead‐endsectionfromtheshippingbracket.

9. Removetheclevispinsecuringtheshippingbrackettofoot‐endsectionfromeachside

ofthefoot‐endsection.SeeDetail“D”ofFIGURE 4.1.

10. Removeshippingbracket andtwocardboardsupportblocksfromfoot‐endbedsection.

11. Unlockthecastersonthefoot‐endsection.

12. Placepowersupplycordandhandsetontopofthebed.

13. Carefullyrollthefoot‐endsectionoffthepallet.

14. Slide head‐endsectionintofoot‐endsectionuntil sideframeholesline up. SeeDetail“E”

ofFIGURE 4.1.

CAUTION

Keep power supply cord and handset clear of the gap between the two sections.

15. Fromtheoutsideofthebed,insertaclevispinintoeachsideframehole.Secureclevis

pinsusingrueringsoninsideofframe.SeeDetail“F”ofFIGURE 4.1.

16. Securetheactuatorstotheframesectionusingtwosmallclevispinsandtwohairpin

clips.SeeDetail“G”ofFIGURE 4.1.

17. Usingthehandcontrol,raisethebedtoitsfullheight.

18. Removelock‐pinfromsupportleglocatedunderfoot‐endsection.

19. Pushsupportlegupandre‐insertlock‐pin.SeeDetail“H”ofFIGURE 4.1.

20. Installtheheadboardpostsintheinwardmostsocketsprovidedattheheadendwith

theboardclosesttothemattress.

21. Installthefootboardpostsintheinwardmostsocketsprovidedatthefootendwith

theboardclosesttothemattress.