4
Step 1
Insert wheels into side holes
at the bottom of the pressure
washer and snap into place.
IMPORTANT PRECAUTIONS – continued
PRECAUTIONS
ASSEMBLY INSTRUCTIONS
Step 2
Place the wheel carriage
onto the mounting brackets
on the sides of the washer
and align the four holes.
Snap into place.
Step 3
Slide the handle into the top
slot of the wheel carriage
and snap into place.
Step 4
Slide the trigger gun holder
into track on the right hand
side of the pressure washer.
Step 5
Pull out the locking slide from the right side of the trigger
gun handle, and insert the small end of the high pressure
hose into place. Push the locking slide back into the trigger
gun to lock the hose in position.
Water Supply (Cold Water Only)
• Water hose must be at least 1/2 inch or
5/8 inch in diameter.
• Flow rate of water supply must not fall
below 2 GPM (gallons per minute).
• Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will
damage the unit. To avoid this risk,
we recommend fitting a water filter.
• Always prevent debris from being drawn
into the unit by using a clean water source
and an accessory water filter if required.
• Save these instructions!
