I
mportant - UK only
●
The wires in the cord are coloured
a
s follows:
B
lue = Neutral
Brown = Live.
●
The appliance must be protected by
a 13A approved (BS1362) fuse.
Note:
●
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
●
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
key
blender
ቢ filler cap
ባ lid
ቤ goblet
ብ blender sealing ring
ቦ blender blade unit
ቧ base
ቨ speed + pulse control
ቩ pre-programmed buttons
ቪ power unit
ቫ cord storage
mill (if supplied)
ቭ mill jar
ቮ mill sealing ring
ቯ mill blade unit
ተ mill base
ቱ mill lid
to use your blender
1 Fit the sealing ring ብ to the blender
blade unit
ቦ marked – ensuring
t
he seal is located correctly in the
grooved area.
●
Leaking will occur if the seal
is damaged or incorrectly
fitted.
2 Clip the blade unit
ቦ into the base
ቧ.
3 Screw the blade assembly onto the
goblet – ensuring the blade
assembly is fully tightened.
4 Put your ingredients into the goblet.
Never blend more than 1.6
litres or more than 1 litre for
frothy liquids like milkshakes.
5 Fit the filler cap to the lid.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the power
unit.
●
The appliance won’t work if
the blender is incorrectly
fitted.
8 Plug in and the 4 pre-program
buttons will light up.
9 Choose one of the following options:
●
Select one of the 4 pre-programmed
buttons (refer to the function selector
chart). When the required program
button is pressed the lights on the
other 3 buttons will go out. The
blender will switch off automatically
at the end of the pre-set time. If you
wish to stop before the pre-set time,
press the selected program button
again.
●
Select speed 1 (low) to 5 (High) by
turning the speed control. At the end
of blending return the speed control
to “0” before removing the blender.
●
(P) Pulse – operates the motor in a
start/stop action. The pulse will
operate for as long as it is held in
position.
3
