BaTTery saver
This transceiver has been designed to give you the most out of
your battery power. The battery saver function decreases the
amount of power used when a signal is not being received and
no operations are being performed.
While using the transceiver, battery saver will automatically
switch ON after 5 seconds have elapsed with no operations or
received calls. Operating the transceiver or receiving a call will
switch this feature OFF until 5 seconds of non-operation occurs
again.
To turn this function on or off:
1 With the transceiver power OFF, press and hold the MENU
key while turning the transceiver power ON (for 1 second).
2 Press the or key to select “ ”.
3 Press the MENU key then press or to select “ ”
(battery saver on) or “
” (battery saver off).
4 Press the MENU key to exit the selection.
5 Press the PTT, MON, or CAL key to exit Setting Mode.
Note: While the Battery Saver is operating, the LED may ash
green when receiving a QT/DQT signal which does not match
the QT/DQT tone/code set up in your transceiver.
