![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/c/17/c1748c8e-926a-4e02-b8d9-0b1705685e42/c1748c8e-926a-4e02-b8d9-0b1705685e42-bg5.png)
5
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Supplied
■ Gas pressure regulator/hose assembly set for 11" (28 cm)
WCP LP gas (attached to manifold)
■ 1 single-prong plug transformer assembly
■ Convertible regulator set for 4" (10.2 cm) WCP Natural gas
■ Orifices for Natural gas conversion
■ LP gas fuel tank tray
Parts Needed
■ 20 lb LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter
Location Requirements
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for built-in outdoor
Power™ burners:
■ A minimum of 24" (58 cm) must be maintained between the
sides and back and any combustible construction.
■ A zero clearance may be maintained below the cooking
surface and any combustible construction.
Ignition
A grounded, 3-prong outdoor GFI outlet is to be located inside
the island cabinet and to the left of the Power™ burner. See
“Electrical Requirements” section.
Product Dimensions
Built-In Outdoor Power™ Burner Enclosure
This built-in outdoor Power™ burner is for installation in a built-in
enclosure constructed of combustible and noncombustible
materials. Some types of noncombustible materials could be
brick, firewall or steel. Some types of combustible materials
could be wood or laminate.
The enclosure for the built-in outdoor Power™ burner is to be a
minimum of 11" (28.0 cm) high x 20" (50.8 cm) deep x
19" (48.6 cm) wide.
■ Tape measure
■ Small, flat-blade screwdriver
■ Flat-blade screwdriver
■ #2 and #3 Phillips screwdriver
■ Level
■ Wrench or pliers
■ Pipe wrench
■ Scissors or cutting pliers
(to remove tiedowns)
■ Noncorrosive leak-
detection solution
A.18
⁷⁄₈
" (47.9 cm)
B.10⁵⁄₈" (27.0 cm)
C.22
⁷⁄₈
" (58.1 cm)
D.23⁵⁄₈" (60.0 cm)
E.22¼" (56.5 cm)
F. Manifold pipe
G.3¼" (8.3 cm)
H.19
¹¹⁄₁₆
" (50.0 cm)
I.20
¹⁵⁄₁₆
" (53.2 cm)
B
A
D
E
F
G
H
B
C
I