58 www.kodak.com/go/support
Troubleshooting
Picture quality problems
Status Possible Solutions
Picture is not clear
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
■ Clean the lens (page 69).
■ Make sure the camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark
■ Reposition the camera for more available light.
■ Use Fill flash (page 9) or change your position so light is not behind
the subject.
■ Move so that the distance between you and the subject is within the
effective flash range (page 63).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
Picture is too light
■ Reposition the camera to reduce the amount of available light.
■ Turn the flash off (page 9).
■ Move so that the distance between you and the subject is within the
effective flash range (page 63).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
■ In Auto and Scene-Custom modes, adjust the Exposure
Compensation (page 35).
