Calibration
Back
IndexContents
Next
93
Calibration Tolerance Level
The calibration tolerance level defines the range
within which a target must fall to be considered
acceptable.
There are three options for tolerance from which
you can choose based on the accuracy and
repeatability of the densitometer and printer:
✔ Loose: Use if you may be redoing the
calibration needlessly because of inherent
statistical noise in the system.
✔ Normal: Use for all your calibrations, unless
you are frequently recalibrating your printer,
especially if you are recalibrating and the
prints look good.
✔ Strict: Use only if you can demonstrate that
your printing system's inherent variability does
not cause needless recalibration, and your
output product demands very tight density
control.
