Utility Mode Operations
7
Di2510/Di3010/Di3510 7-31
7.4 Registering an Image Stamp
Before the Auxiliary function “Image Stamping” can be used, an image
must be registered. A maximum of five images can be registered. For
details on using the “Image Stamping” function, refer to ““Image
Stamping” Function” on page 6-17.
✎
Note
The optional hard disk must be installed.
To register an image stamp
1 Press the [Utility] key.
2 Touch [User Set].
3 Touch [Image Mem. Input].
4 Touch [Input], and then touch
desired registration key.
❍ To erase a stored image, touch
[Delete], and then touch the
number from where you wish to
delete the image.
❍ To check a stored image, touch
[Check], and then touch the
number where the image that
you wish to check is stored.
