3-2
Copying
Basic Operation
Follow the steps as below for basic copying.
1 Configure necessary settings in KYOCERA Client Tool in advance. Refer to Machine
Settings
on page 2-22.
2 Press [Copy].
3 Place the originals. For details, refer to Loading Originals on page 2-16.
4 To use a program, select the program number (P0 to P3).
Press the Mode Select key to select Program, and press [] or [] to select the program
number.
5 Enter the number of copies.
Press the Mode Select key to select Copies, and press [] or [] to enter the number of
copies.
6 Adjust density using 7 levels (-3 (Lighter) to 3 (Darker)).
Press the Mode Select key to select Density, and press [] or [] to select your desired
density.
7 Press [Start] to start copying.
Note For details on functions that are registered in programs, refer to Using
Programs on page 3-5.
P0 is the status with no program set.
