The following illustration shows the locations of parts on the system board.
1Speaker connector 12PCI adapter connector 1
2 Memory connector 4 13PCI adapter connector 2
3 Memory connector 3 14Serial connector
4 Memory connector 2 15PCI Express (x1) adapter connector
5 Memory connector 1 16Clear CMOS/Recovery jumper
6 Front panel I/O connector 17Battery
7 Power supply connector 18Microprocessor fan connector
8 PATA IDE connector 19Microprocessor
9 System fan connector 20Microprocessor heat sink
10 SATA connectors 2112v power connector
11 PCI Express (x16) graphics adapter
connector (some models)
22Diskette drive connector
Installing memory
Your computer has four connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 4.0 GB of system memory.
When installing DDR2 type memory modules, the following rules apply:
v Use 1.8 V, 240-pin double data rate 2 synchronous dynamic random access
memory (DDR2 SDRAM).
v Use 256 MB, 512 MB or 1.0 GB memory modules in any combination.
To
install a memory module:
1. Removing the cover. See “Removing the cover” on page 10.
12 User Guide
