Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
8. Turn on the computer and all attached devices.
9. Use the Setup Utility program to set the date and time and any passwords. See
Chapter 2, “Using the Setup Utility,” on page 31.
Erasing a lost or forgotten password (clearing CMOS)
This section applies to lost or forgotten passwords. For more information about
lost or forgotten passwords, go to the ThinkVantage Productivity Center.
Note: If you are enrolled in the Hardware Password Reset program, refer to
“Resetting the hard disk drive and power-on password” on page 33 to reset
your password. If you do clear CMOS or restore Setup Utility defaults, you
will have to re-enroll in the Hardware Password Reset program.
To erase a forgotten password:
1. Open the computer cover. See“Opening the cover” on page 11.
2. Locate the Clear CMOS/Recovery jumper on the system board. See
“Identifying parts on the system board” on page 13.
3. Move the jumper from the standard position (pins 1 and 2) to the maintenance
or configure position (pins 2 and 3).
4. Lower the drive bay assembly and reconnect any cables that were
disconnected.
5. Close the computer cover and connect the power cord. See “Closing the cover
and connecting the cables.”
6. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
7. Repeat steps 1 and 2 on page 28.
8. Move the Clear CMOS/Recovery jumper back to the standard position (pins 1
and 2).
9. Close the computer cover and connect the power cord. See “Closing the cover
and connecting the cables.”
Closing the cover and connecting the cables
After working with options, you need to install any removed parts, close the
computer cover, and reconnect cables, including telephone lines and power cords.
Also, depending on the option that is installed, you might need to confirm the
updated information in the Setup Utility program.
To close the computer cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer.
2. Make sure that the cables are routed correctly before lowering the drive bay
assembly.
3. Lower the drive bay assembly.
4. Close the computer cover.
5. Install any locking devices such as an integrated cable lock as necessary.
28 User Guide
