A SERVICE OF

logo

Open as PDF
next previous
Installing a drive in bay 1
To install an optical drive or an additional hard disk drive in bay 1, do the
following:
1. Open the computer cover. See “Opening the cover” on page 21.
2. Remove the plastic panel from the front bezel.
3. Remove the metal shield from the drive bay by using a flat-blade screwdriver
to gently pry it loose.
4. For a 5.25-inch drive, install a retainer bracket on the side of the drive.
5. For a 3.5-inch drive, install the drive into the Universal Adapter Bracket, 5.25 to
3.5-inch.
Note: If you are installing a 3.5-inch hard disk drive you must use a Universal
Adapter Bracket, 5.25 to 3.5-inch. You can obtain this bracket from a local
computer retailer or by contacting the Customer Support Center.
Chapter 3. Installing options 29