A SERVICE OF

logo

3. Move the jumper from the standard position (pins 1 and 2) to the maintenance
or configure position (pins 2 and 3).
4. Replace the computer cover and connect the power cord. See Chapter 4,
“Completing the parts replacement,” on page 47.
5. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
6. Repeat steps 1 through 2 on page 50.
7. Move the Clear CMOS/Recovery jumper back to the standard position (pins 1
and 2).
8. Replace the computer cover and connect the power cord. See Chapter 4,
“Completing the parts replacement,” on page 47.
Chapter 5. Security features 51