A SERVICE OF

logo

5. Install the new drive into the blue bracket, flex the bracket, and align the pins
1 through 4on the bracket with the holes in the hard disk drive. Do not
touch the circuit board 5 on the bottom of the hard disk drive.
6. Connect the signal and power cables to the rear of the hard disk drive.
7. Position the hard disk drive and bracket so that it engages the retaining clips in
the bottom of the chassis when you slide the bracket to the right.
8. Slide the hard disk drive and bracket to the right until it snaps into position.
9. Go to Chapter 4, “Completing the parts replacement,” on page 33.
Figure 23. Aligning the pins with the holes in the hard disk drive
22 Hardware Installation and Replacement Guide