11. Carefully close the microprocessor retainer. Then, carefully close the small handle to lock the retainer
into position and secure the new microprocessor in the socket.
Figure 93. Securing the microprocessor in the socket
12. Install the new heat sink that comes with the microprocessor option kit. See “Installing or replacing a
heat sink” on page 133.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 174.
Replacing the microprocessor
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii
and “Guidelines” on page 81.
This topic provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the server and wait three to ve minutes
to let the server cool before removing the server cover.
Chapter 6. Installing, removing, or replacing hardware 139
