Making a copy lighter or darker
If you want to adjust the look of a copy or photo, you can adjust it to make it lighter or darker.
1 Load paper.
Note: If you are copying photos, use photo or heavyweight matte paper, with the glossy or printable side facing
down. (If you are not sure which side is the printable side, see the instructions that came with the paper.)
2 Load an original document faceup into the Automatic Document Feeder (ADF) or facedown on the scanner glass.
Note: Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine
clippings) into the Automatic Document Feeder (ADF). Place these items on the scanner glass.
3 From the control panel, press
or repeatedly until Copy is highlighted.
4 Press .
The Copy Mode menu appears.
5 Press or repeatedly until you reach the Lighter/Darker menu item.
6 Press or repeatedly to adjust the slider.
7 Press
Note: If you are using the scanner glass, a message appears prompting you for additional pages.
Adjusting copy quality
Quality specifies the resolution used for the copy job. Resolution involves a dots-per-inch (dpi) count; the higher the
dpi count the higher the resolution and copy quality.
1 Load paper.
2 Load an original document faceup into the Automatic Document Feeder (ADF) or facedown on the scanner glass.
3 From the control panel, press or repeatedly until Copy is highlighted.
4 Press .
The Copy Mode menu appears.
5 Press or repeatedly until the Quality menu item appears.
6 Press or until the value you want appears.
• Press to see a preview before printing.
• Press to print immediately.
Canceling a copy job
You must have started a copy job to complete this task.
1 Wait for the Copy Mode screen to appear.
2 Press
.
Note: If the copy job contained multiple pages loaded into the Automatic Document Feeder (ADF), the copy stops
printing on the page it was on when you pressed
. This page ejects as an incomplete copy.
118
