24
To Configure the Amplifier for Three Channel UseTo Configure the Amplifier for Three Channel Use
1.
11 Connect the left front channel interconnect from your pre-amp
or source component to the CHANNEL 1 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 1
BAL/UNBAL switch towards the connector that is being used.
22 Connect the right front channel interconnect from your pre-amp
or source component to the CHANNEL 6 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 6
BAL/UNBAL switch towards the connector that is being used.
33 Connect the center channel interconnect from your pre-amp or
source component to the CHANNEL 3 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 3
BAL/UNBAL switch towards the connector that is being used.
44 Flip the LINK INPUT 6 TO 5/UNLINK (NORMAL) switch “ON”, or up
towards LINK INPUT 6 TO 5. Flip the LINK INPUT 4 TO 3/UNLINK
(NORMAL) switch “ON”, or up towards LINK INPUT 4 TO 3. Flip the
LINK INPUT 2 TO 1/UNLINK (NORMAL) switch “ON”, or up towards
LINK INPUT 2 TO 1.
55 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 1 to CHANNEL
2.
66 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 3 to CHANNEL
4.
77 Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 5 to CHANNEL
6.
88 Connect your left front loudspeaker cable to the Channel 1
SPEAKER OUTPUT connector.
99 Connect your right front loudspeaker cable to the Channel 5
SPEAKER OUTPUT connector.
1010 Connect your center channel loudspeaker cable to the Channel
3 SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.
