E-EQ-TX800OGWW-D-ARC 9
2 Safety
2.1 2.1 Personal safety
Keep this in mind:
Always exercise caution when working with electricity
2.2 Product safety
2.2.1 Supplying power
Tx800 have to be supplied with an external fuse before connecting to recommended voltage (see 4.2.1).
Connect only the recommended voltage. Any other voltage may damage the product or make its operation
fail.
The external electrical system should be designed to prevent voltage peaks.
A DC/DC transformer is predominantly used to electrically isolate the Tx800 from the vehicle chassis (see
4.2.1).
2.2.2 Humidity, moisture, cold and heat
Make sure the operating environment is within the standards described in Appendix I, Technical specs.
Don’t turn the Tx800 on, unless environmental conditions are met.
2.2.3 Interference
Ensure that:
• Any nearby electrical cabling (mains supply) is run so that interference does not occur.
• The immediate environment meets requirements stated in the specified standards (see
Appendix IV) regarding interference
2.2.4 Vibrations
Tx800 should be mounted in a way that vibrations, transmitted to it, does not exceed the limits it is
designed for (see Appendix I, Specifications).
