50
Appendix
TipsSettingsConnections
Contents
Front panel Display Rear panel IndexRemote
Playback
2 Files that can be played back
See “D/A converter” (vpage70).
NOTE
•Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
•You can also control the volume and equalizer on the computer. Enjoy playing
music at the desired volume.
•When this unit is functioning as a D/A converter, sound is not output from the
computer’s speakers.
•If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
•When an abnormality occurs on the computer, disconnect the USB cable and
restart the computer.
•The sampling frequency of the music playback software and sampling frequency
displayed on this unit may dier.
2 Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB-DAC port to connect this unit to a computer.
For the connection procedure, refer to the “Connecting a PC or Mac”
(vpage21) section.
1
Press INPUT to change the media mode to “USB-DAC”.
Start playback on the computer’s player software.
The input digital audio signal is displayed as shown.
“USB : xxxxk“
or
“USB : DSD xxxM“
(xxxx is the sampling frequency.)
•If the sampling frequency cannot be detected, “Unlock” will be
displayed.
