Installation
Maxtor DiamondMax 17 80-160GB AT Hard Disk Drive 3-5
The configuration of the following three jumpers controls the drive’s five modes of
operation:
–CS – Cable Select
–DS – Drive Select
–CLJ– Cylinder Limitation Jumper
The AT PCB has two jumper locations provided to configure the drive in a system.
The default configuration for the drive as shipped from the factory is with a jumper
across the CS location, and open positions in the DS and CLJ positions.
Table 3-1 defines the operation of the master/slave jumpers and their function
relative to pin 28 on the interface.
1
indicates that the specified jumper is installed;
0
indicates that the jumper is not installed.
Table 3-1
AT Jumper Options
Note: In Table 3-1, a
0
indicates that the jumper is removed, a
1
indi-
cates that the jumper is installed, and an X indicates that the
jumper setting does not matter.
CS DS Pin 28 DESCRIPTION
00 X Drive is configured as a slave.
10 Gnd Drive is configured as Master (Device 0) when attached to the end of a 80
conductor Ultra ATA cable.
01 X Drive is configured as a Master.
10Open Drive is configured as a Slave (Device 1) when attached to the middle of a 80
conductor Ultra ATA cable.
11 XDrive is configured as a Master with an attached slave that does not support
DASP.
