224
Control systems
COMAND navigation system (entering a destination)
Subsequent destination entries may differ,
depending on your selection:
ț “Address Entry” selection:
̈ Enter a destination by address
(
୴ page 198).
ț “From Memory” selection:
̈ Enter a destination from the desti-
nation memory (
୴ page 219).
ț “From Last Destinations” selection:
̈ Enter a destination from the list of
last destinations (
୴ page 221).
ț “From POIs” selection:
̈ Enter a special destination
(
୴ page 225).
̈ Starting route calculation: After
entering a destination, select “Start”
(
୴ page 218).
Changing a stopover
If a stopover has already been entered, you
can change it.
̈ Select “Navi” Ǟ “Destination” Ǟ
“Stopover” Ǟ “Change Stopover”.
̈ Enter another destination as a stop-
over.
Deleting the stopover
If a stopover has already been entered, you
can delete it.
̈ Select “Navi” Ǟ “Destination” Ǟ
“Stopover” Ǟ “Delete Stopover”.
COMAND deletes the stopover and cal-
culates the route to the main destina-
tion.
