26
2
Hardware Installation
2.9.3 PS/2 Mouse Port
The PS/2 mouse port is a 6-pin connector on the system board.
Attach the 6-pin mouse port cable, which is mounted on a card-
edge bracket, to connector J1. Make sure the red wire on the PS/2
mouse connector is aligned with pin 1 of connector J1. Mount the
card-edge bracket to the system chassis.
Pin
1
2
3
4
5
6
Function
Mouse Data
Reserved
Ground
+5V
Mouse Clock
Reserved
2.9.4 Parallel Port
The system board has a stan-
dard printer port for interfacing
your PC to a parallel printer. It
supports SPP, ECP and EPP
modes. You can set the ports
mode in the Integrated Peripher-
als setup of the Award BIOS.
Connecting the Parallel Printer
Port
Attach the DB-25 printer port
cable to connector J9 on the
system board. Make sure the colored stripe on the ribbon cable
aligns with pin 1 of J9. Use a small nutdriver to mount the cable
into a DB-25 cutout in the system chassis. If your printer port cable
is attached to a card-edge bracket, connect the cable to connector
J9 on the system board and mount the card-edge bracket to the
system chassis.
