
LT12D50SA LIGHT TOWER • OPERATION MANUAL — REV. #0 (03/16/09) — PAGE 21
To check the engine fuel level, make sure the light 1.
tower is placed on secure level ground with the engine
stopped.
Lift the light tower access door (Figure 7) opposite the 2.
control panel. Set the door support latch in place to
keep the door open (up).
Adding FuelFigure 7.
Remove the fuel cap from the fuel tank.3.
Pay attention to the fuel tank capacity when replenishing 4.
fuel. The fuel tank cap must be closed tightly after fi lling.
Handle fuel in a safe container. If the container does
not have a spout, use a funnel.
Wipe up any spilled fuel immediately!5.
BATTERY CHECK
CAUTION
ALWAYS fi ll the fuel tank with clean, fresh #2 diesel
fuel. DO NOT fi ll the fuel tank beyond its capacity. DO
NOT TOP-OFF.
WARNING
The operator must wear the appropriate
protective equipment and clothing while
handling the battery.
Failure to wear protective equipment or clothing could
result in serious injury.
INSPECTION
The 12-volt DC battery (Figure 8) is shipped dry and will
require a proper electrolyte level for operation.
BatteryFigure 8.
When servicing of the battery is required, perform the
following:
A face shield and rubber gloves should be worn while
handling and servicing the battery's electrolyte.
Disconnect battery terminal clamps, and remove the
battery from the generator cabinet when servicing is
required.
DO NOT overfi ll the battery.
WARNING
Electrolyte is an acid and must be
handled with caution. ALWAYS follow
servicing instructions from the electrolyte
manufacturer to ensure safety. Serious
injury can result from careless handling and
noncompliance to safety handling instructions.
Overfi lling the battery may cause the electrolyte to
overfl ow resulting in corrosion to nearby components.
Immediately wash off any spilled electrolyte (battery
acid).
WARNING
When connecting the positive (+) cable
to the battery's positive (+) terminal post,
DO NOT allow the wrench or any metallic
part to come in contact with the battery's
negative (-) terminal post. This may result in an electrical
short circuit or an explosion. Always connect positive
(+) end fi rst then negative (-) end. Always disconnect
(-) end fi rst then positve (+) end.
NOTICE
Use only distilled water in the battery. Tap water can
reduce the operating life of the battery.