1. To check the engine fuel level, make sure the light
tower is placed on secure level ground with the engine
stopped.
2. Lift the light tower access door (Figure 9), control panel
side. Set the door support latch in place to keep the
door open (up).
Figure 9. Adding Fuel
3. Remove the fuel cap from the fuel tank.
4. Pay attention to the fuel tank capacity when replenishing
fuel. The fuel tank cap must be closed tightly after filling.
Handle fuel in a safe container. If the container does
not have a spout, use a funnel.
5. Wipe up any spilled fuel immediately!
Diesel fuel and its vapors are dangerous
to your health and the surrounding
environment. Avoid skin contact and/or
inhaling fumes. smoke while
refueling. attempt to refuel the
light tower if the engine is hot or running.
FUEL
ALWAYS fill the fuel tank with clean, fresh #2 diesel
fuel. fill the fuel tank beyond its capacity. DO
.
inspection
The 12-volt DC battery (Figure 10) is shipped wet and is
ready for use.
Figure 10. Battery (
When servicing of the battery is required, perform the
following:
A face shield and rubber gloves should be worn while
handling and servicing the battery's electrolyte.
Disconnect battery terminal clamps, and remove the
battery from the generator cabinet when servicing is
required.
overfill the battery.
The operator must wear the appropriate
protective equipment and clothing while
handling the battery.
Failure to wear protective equipment or clothing could
result in serious injury.
Electrolyte is an acid and must be
handled with caution. ALWAYS follow
servicing instructions from the electrolyte
manufacturer to ensure safety. Serious
injury can result from careless handling and
noncompliance to safety handling instructions.
Overfilling the battery may cause the electrolyte to
overflow resulting in corrosion to nearby components.
Immediately wash off any spilled electrolyte (battery
acid).
