Arming Your System When Leaving
1
Before armin
your system, make sure the
reen
Status
li
ht is ON. This indicates that all of your protective zones are
secure. If any zones are open, the correspondin
Zone number will be lit. Secure these zones before proceedin
. If any
zones cannot be secured, see Bypassin
zones below.
2
Enter your user code and press
.
The
reen
Status
li
ht will
o out, the red
Armed
li
ht will li
ht.
•
If you make a mistake enterin
your code, press , re-enter the code and press
.
3
Leave the premises throu
h the Exit/Entry door. If the keypad
ives a steady tone you have taken too lon
. Enter your code
a
ain to disarm system and then re-enter code and leave.
Easy Arm
The optional Easy Arm feature allows the system to be armed by simply pressin
.
This will allow the easy armin
of the system by someone who is not a re
ular system user.
Bypassing Zones
If an open zone cannot be immediately fixed it can be left unprotected, or
bypassed
,while the rest of the system is Armed.
To bypass a zone:
1
Press followed by the number of the zone to be bypassed. The bypassed zone’s number will flash slowly.
2
Enter your user code and press
.
The
reen
Status
li
ht will
o out and the red
Armed
li
ht will li
ht.
3
Leave the premises throu
h the Exit/Entry door.
When the system is subsequently disarmed, all bypassed zones will be reset, ready to be armed a
ain. If it is necessary to
bypass any inoperative zone(s), it is important to have the zone(s) repaired as soon as possible.
A bypassed zone does not provide any protection, compromising system security.
Arming Your System
6
Oi230a
page 6
Tuesday, September 16, 1997 08:26
