25
PROGRAMMING (OPTIONAL)
6. Continuing, set the cursor to the
user code with the A button and enter
the new User Code using the number but-
tons. Press G0 for any blank loca-
tions until you end up back to the flashing
“UP”.
7. Press the Jbutton to save the code
in memory.
Repeat Steps 4 through 7 for each
user.
Note: To void a code, simply enter the
2-digit user number, then press the Jbut-
ton.
Programming Example
Example. Program User 3's Code as
“3784”.
1. Select the Program Mode as follows:
(a) Enter your code, then press the
A button.
(b) Answer NO (F button) repeatedly until “17” is displayed, then press the YES (E button). The display will scroll “P”
followed by 4 digits (for installer's use), then “UP” (indicating user programming) and the lights will continue to flash.
2. Press the A button then 03 to enter User No. 3, then press the A button again followed by
3784 G0 G0 to program the code.
Programming User Codes
To Program User Codes
1. Enter program code, then press
the A button.
2. Press NO (F) until “17”
displays, then press YES
(E).
3. When “UP” displays with a
flashing light, use the number
buttons to enter a 2-digit user
number followed by a user code
of up to 6 digits.
4. Press the Jbutton to save.
5. Repeat steps 3 & 4 to enter all
user codes.
6. Press the C button to exit.
NOTE: Press G 0 button to clear character at cursor.
To continue press E or F button.
GEM-RP3DGTL.pub
page 25
Wednesday, August 18, 1999 14:03
