Troubleshooting
Additional information
EN-36
When paper is jammed
When paper is jammed, the ACCESS and PAPER indicators blink and printing stops.
Follow these steps to remove jammed paper.
1 Turn off the printer.
2 Remove the paper-in tray.
3 Turn on the printer again. The paper should be ejected automatically.
• If the paper is automatically ejected, go to Step 8.
• If the paper is not automatically ejected, turn off the printer and go to Step 4.
4 Check the inside of the paper-in tray door to see whether paper is visible at the rear.
• If it is, go to Step 5.
• If it is not, contact an authorized Olympus service center.
5 Open the ribbon cartridge door. Use a flathead screwdriver to turn the screw in the
counterclockwise or clockwise direction.
Notes
• Do not pull the jammed paper too hard. The paper may tear inside the printer.
• Jammed paper that has been removed cannot be used for printing. If it is used, a printer failure might occur.
Screw
Doya_E.book Page 36 Thursday, November 11, 2004 10:50 AM
