
Using a Computer
By connecting the unit to a computer, you can use the
unit’s microphones and speaker for calls made or
received with the computer using your preferred IP
phone software.
Connecting a Computer
Connect the included PC Cable to the [AUDIO IN/
OUT] jack of the unit (A), and to the microphone jack
(red plug; B) and headphone jack (green plug; C) of
the computer.
Note
• The microphone and speaker of the computer
cannot be used while the computer is
connected to the unit.
Line Selection (IP + PC)
1. Press [MENU].
2. Press
.
3. Select "IP + PC".
• When "Line Selection" is set to "IP + PC",
TEL calls cannot be made or received.
4. Press
.
5. Press [MENU].
Using a Computer
1. Confirm that "PC" is shown in the upper-right corner
of the display.
• You can change the selected line by pressing
the center function button ([F2]).
The IP line is selected. The PC line is selected.
[F2] [F2]
• If you cannot select "PC", change the "Line
Selection" setting to "IP + PC" (explained
on this page).
2. Press [
] to begin using the unit’s microphones
and speaker.
• Press [ ] again to turn off the microphones
and speaker.
3. Use the desired computer software to make or
answer a call.
4. Use the computer to end the call.
5. Turn off the unit’s microphones and speaker by
pressing [
].
Note
• Leave at least 50 cm (about 20 in.) of space
between the unit and the computer.
42 Operating Instructions Document Version 2008/10
Using a Portable Station (PS) or Computer