102
8. Insert the power cord plug into the wall outlet and then press the MAIN POWER
switch.
• If the power does not turn on (power indicator lamp (red) does not turn on) even after turning the
MAIN POWER switch “I”, turn the MAIN POWER “
O
”, confirm that the lamp unit and door are
installed correctly, and turn on again.
9. Press the “I” (POWER) button so that a picture is projected onto the screen.
10. Press the “MENU” button to display
the MAIN MENU screen, and then
press the and buttons to move
the cursor to select “OPTION”.
13. Press and hold the “ENTER” button
on the projector or the remote control
for approximately 3 seconds.
An item “LAMP RESET” will be added.
14. Select the lamp which has been
replaced with the and buttons.
LAMP1: Replace the LAMP UNIT 1
LAMP2: Replace the LAMP UNIT 2
11. Press the “ENTER” button to display
the “OPTION” screen, and select
“SYSTEM INFORMATION” with the
and buttons.
12. Press the “ENTER” button.
The SYSTEM INFORMATION screen will be
displayed.
15. Press the “ENTER” button. When
“OK?” is displayed, press the
“ENTER” button.
The used hours of the specified lamp unit will be
reset to zero.
When more than one lamp has been replaced,
repeat the procedure from step 14.
