FAQs, etc.
27
Input signal that can be displayed
∗
Mark: Applicable input signal for Component (Y, PB/CB, PR/CR) and HDMI
Note
•
Signals other than above may not be displayed properly.
•
The above signals are reformatted for optimal viewing on your display.
Signal name Horizontal frequency (kHz) Vertical frequency (Hz) Component HDMI
480i (60 Hz) 15.73 59.94
∗∗
480p (60 Hz) 31.47 59.94
∗∗
576i (50 Hz) 15.63 50.00
∗∗
576p (50 Hz) 31.25 50.00
∗∗
720p (60 Hz) 45.00 60.00
∗∗
720p (50 Hz) 37.50 50.00
∗∗
1,080i (60 Hz) 33.75 60.00
∗∗
1,080i (50 Hz) 28.13 50.00
∗∗
1,080i (50 Hz)*
1
31.25 50.00
∗
•
Technical Information
Stereo / Bilingual Sound Selection
Note
•
If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switching
occurs, it is recommended you switch from STEREO to MONO.
•
Even when the contents of the receiving signal undergo changes, selection mode is kept intact.
•
When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position, using
the stereo / bilingual sound selection button.
•
DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.
*
1
Based on SMPTE295M standard
When you receive the stereo / bilingual sound system, sound output modes can be selected by pressing
the Stereo / Bilingual Sound Selection button.
Audio Signal STEREO
MAIN
I
SUB
II
MONO
Mode Indicator
I II
NICAM .......Used in New Zealand, Singapore, Hong Kong etc.
Type of broadcast
Regular broadcast
(Standard Audio)
Regular + NICAM MONO
I
(MAIN
I
)
NICAM STEREO
NICAM DUAL MONO
(MAIN
I
/ SUB
II
)
Mode Indicator
No Indicator
I
I
II
A2(German) .......Used in Australia, Malaysia etc.
Type of broadcast
Regular broadcast
(Standard Audio)
BILINGUAL or DUAL MONO:
MAIN
I
/ SUB
II
STEREO
Mode Indicator
No Indicator
III
